Good to know
- The lip height is after folding; the support and feet are measured on the flat sheet from the support fold.
- Set the device thickness with its case on: the ledge is sized so the device sits upright against the support.
- For a large tablet use a support of 150 mm or more, feet of 150 mm or more and 2 mm sheet (the lip then needs to be at least 19 mm to fold).
- The cable hole suits a charger cable run up behind the support, for a device in landscape or a wireless charging pad.
- Add stick-on rubber feet underneath so it does not slide or scratch the desk.
Phone and tablet stand
By Brox Metals
A one-piece stainless stand for a phone or tablet: the back support folds up out of the base, with a front lip to hold the device and an optional cable hole. Set the lean angle and the size of your device.
- Made by
- Laser cutting and folding
- Shown in
- Stainless Steel 304 Hairline 1.5 mm
- Overall size as shown
- 158 × 149 × 105 mm
RM 52.85 for one as shown, before tax.
Order this partSet your sizes, choose your material, finish and quantity, and see the price and ready date before you pay.
What you can change
| As shown | You can choose | |
|---|---|---|
| Support width | 90 mm | 50 to 250 mm |
| Support length | 110 mm | 60 to 220 mm |
| Lean angle | 70° | 55 to 80° |
| Device thickness | 12 mm | 6 to 25 mm |
| Lip height | 14 mm | 14 to 30 mm |
| Foot width | 30 mm | 15 to 60 mm |
| Foot length | 130 mm | 50 to 250 mm |
| Cable hole | Yes | Yes or no |
| Cable hole size | 22 mm | 12 to 70 mm |
| Finished face | Front (the side the device rests on) | 2 choices |
Some ranges depend on the other sizes and on the metal you choose.