Good to know
- One ear fits either side of the device: turn it over for the other side. Order 2 per device.
- The rack slot centre is 8.75 mm in from the ear tip, so a pair spans 465.1 mm between slots (EIA-310).
- M6 slots go on the middle hole of each U: on the top and bottom holes they would leave under 3 mm of metal at the edge, our minimum.
- Measure the holes on the side of your device from its front face, and check its width over any handles.
- Screw heads on the side flange sit between the rack rails (450 mm opening): use countersunk screws if the device is close to that.
19-inch rack mount ears
By Brox Metals
L-shaped ears that turn any box into 19-inch rack equipment: slots on the standard rack pattern at the front and screw holes on a side flange to suit your device. One design fits both sides.
- Made by
- Laser cutting and folding
- Shown in
- Aluminium Mill finish 2 mm
- Overall size as shown
- 45 × 44 × 26 mm
RM 15.00 for one as shown, before tax.
Order this partSet your sizes, choose your material, finish and quantity, and see the price and ready date before you pay.
What you can change
| As shown | You can choose | |
|---|---|---|
| Height | 1U (43.66 mm) | 2 choices |
| Rack screws | M6 cage nuts (6.5 mm slots) | 2 choices |
| Slot positions | Middle hole of each U | 2 choices |
| Device width | 430 mm | 250 to 445 mm |
| Side flange length | 45 mm | 40.4 to 200 mm |
| Device screws | M4 (4.5 mm holes) | 5 choices |
| First hole from front | 15 mm | 6.8 to 100 mm |
| Holes along the side | 2 | 1 to 6 |
| Hole spacing | 20 mm | 7.5 to 100 mm |
| Rows of holes | 1 | 1 to 2 |
Some ranges depend on the other sizes and on the metal you choose.