Good to know
- Sizes are after folding: depth runs from the front of the folded edge to the back of the upstand.
- Left and right are as you stand at the front of the worktop.
- The sink cut-out sits 60 mm from the front edge with 15 mm corners, to suit inset (top-mount) sinks; take its size from your sink's sheet.
- The 35 mm tap hole is centred 50 mm behind the sink cut-out: check your sink's rim and tap base fit there.
- Cut-outs keep at least 100 mm from the ends and 150 mm from each other; follow your hob maker's clearances too.
- The ends are cut square and left open. Bond the worktop to an 18 to 25 mm water-resistant board for support.
Stainless kitchen worktop with sink and hob cut-outs
By Brox Metals
A one-piece stainless steel worktop with a folded front edge, a back upstand, a sink cut-out with a tap hole and a hob cut-out, made to your kitchen's sizes. Bond it to a water-resistant board on top of your cabinets.
- Made by
- Laser cutting and folding
- Shown in
- Stainless Steel 304 Hairline 1.2 mm
- Overall size as shown
- 2000 × 600 × 139 mm
RM 664.06 for one as shown, before tax.
Order this partSet your sizes, choose your material, finish and quantity, and see the price and ready date before you pay.
What you can change
| As shown | You can choose | |
|---|---|---|
| Length | 2000 mm | 1925 to 3000 mm |
| Depth | 600 mm | 592.5 to 900 mm |
| Front edge height | 40 mm | 25 to 60 mm |
| Back upstand height | 100 mm | 40 to 150 mm |
| Sink | Sink cut-out and tap hole | 3 choices |
| Sink cut-out width | 760 mm | 300 to 1000 mm |
| Sink cut-out depth | 440 mm | 300 to 447.5 mm |
| Sink centre from left end | 600 mm | 480 to 1520 mm |
| Hob cut-out | Yes | Yes or no |
| Hob cut-out width | 650 mm | 250 to 800 mm |
| Hob cut-out depth | 380 mm | 200 to 480 mm |
| Hob centre from left end | 1500 mm | 1455 to 1575 mm |
| Coloured side | Outside of the bend between Front edge and Worktop | 2 choices |
Some ranges depend on the other sizes and on the metal you choose.