Good to know
- Socket cut-outs suit 13 A sockets (BS 1363 / MS 589) on standard flush back boxes: 76 x 76 mm for a single, 136 x 76 mm for a double. The faceplate covers the cut edge.
- The back boxes must sit flush with the wall. You may need longer faceplate screws to reach through the panel.
- Fixings run along the top and bottom edges. Use a panel adhesive as well on large panels.
- Welded studs go on the back of the panel, so nothing shows on the front. On thin sheet we check first that the welds won't mark the finish.
- Countersunk holes need thicker sheet than most splashbacks; we tell you if your gauge is too thin.
Stainless splashback with power-point cut-outs
By Brox Metals
A flat stainless steel splashback panel for the wall behind a worktop or hob, with cut-outs for up to three wall sockets and your choice of fixing: screw holes, countersunk holes or hidden welded studs on the back.
- Made by
- Laser cutting
- Shown in
- Stainless Steel 304 Hairline 1.2 mm
- Overall size as shown
- 2000 × 600 mm
RM 624.44 for one as shown, before tax.
Order this partSet your sizes, choose your material, finish and quantity, and see the price and ready date before you pay.
What you can change
| As shown | You can choose | |
|---|---|---|
| Width | 2000 mm | 1798 to 3000 mm |
| Height | 600 mm | 308 to 1000 mm |
| Socket type | Double socket (146 x 86 mm plate) | 2 choices |
| Number of sockets | 2 | 0 to 3 |
| Socket height | 200 mm | 108 to 492 mm |
| Socket 1 from left | 300 mm | 98 to 1544 mm |
| Socket 2 from left | 1700 mm | 456 to 1902 mm |
| Fixing | Screw holes (4.5 mm, for dome-head screws) | 6 choices |
| Fixing spacing | 500 mm | 200 to 900 mm |
| Fixing inset | 30 mm | 15 to 150 mm |
Some ranges depend on the other sizes and on the metal you choose.