Good to know
- All sizes are outside sizes of the folded cover. It fits over a chassis whose outside width is the top width less two sheet thicknesses.
- The screw holes sit on the same line on both sides, measured up from the bottom edge.
- The vent slots run across the top, centred, and fill the length between the two vent margins.
Enclosure cover with vents
By Brox Metals
A U-shaped lid for an electronics box: a flat top with a block of vent slots and two folded sides with screw holes along their bottom edge. Set the size, the vents and the screws to suit your chassis.
- Made by
- Laser cutting and folding
- Shown in
- Aluminium Mill finish 1.5 mm
- Overall size as shown
- 200 × 120 × 50 mm
RM 67.57 for one as shown, before tax.
Order this partSet your sizes, choose your material, finish and quantity, and see the price and ready date before you pay.
What you can change
| As shown | You can choose | |
|---|---|---|
| Cover length | 200 mm | 84 to 1200 mm |
| Top width | 120 mm | 80 to 600 mm |
| Side height | 50 mm | 18.7 to 120 mm |
| Vent slots | Yes | Yes or no |
| Slot length | 60 mm | 6 to 100 mm |
| Slot width | 4 mm | 3 to 10 mm |
| Metal between slots | 6 mm | 3 to 40 mm |
| Vent block from the ends | 40 mm | 10 to 98 mm |
| Screw size | M3 (3.4 mm hole) | 3 choices |
| Screws per side | 2 | 1 to 12 |
| End screws from the ends | 20 mm | 4.7 to 93.3 mm |
| Screw height | 8 mm | 4.7 to 39.3 mm |
Some ranges depend on the other sizes and on the metal you choose.