Good to know
- Fits 35 mm top-hat DIN rail (EN 60715 TS35); the rail runs along the bracket width and is centred on the rail flange.
- Sizes are outside sizes of the folded bracket. Use two or more brackets per rail, about every 300 mm.
- Foot slots run in and out from the upright, so the rail can be lined up after drilling the panel.
- Bare stainless or mild steel keeps the rail earthed through the bracket; on a powder-coated bracket, fit a separate earth link.
- With a tilt, the stand-off height is the length of the upright, not the height of the rail.
DIN rail stand-off bracket
By Brox Metals
A Z-shaped bracket that holds a standard 35 mm DIN rail clear of a wall or panel, leaving room for wiring behind it. Slotted foot for adjustment, holes for the rail screws, and an optional tilt to angle the rail.
- Made by
- Laser cutting and folding
- Shown in
- Stainless Steel 304 2B 2 mm
- Overall size as shown
- 70 × 40 × 30 mm
RM 16.76 for one as shown, before tax.
Order this partSet your sizes, choose your material, finish and quantity, and see the price and ready date before you pay.
What you can change
| As shown | You can choose | |
|---|---|---|
| Bracket width | 40 mm | 30 to 1000 mm |
| Stand-off height | 30 mm | 20 to 150 mm |
| Foot depth | 30 mm | 25 to 80 mm |
| Rail flange depth | 42 mm | 39 to 80 mm |
| Rail tilt | 0° | 0 to 45° |
| Panel screws | M5 (5.5 mm slots) | 3 choices |
| Number of slots | 2 | 1 to 3 |
| Slot length | 12 mm | 5.5 to 12 mm |
| Rail screws | M5 (5.5 mm holes) | 3 choices |
| Number of rail holes | 1 | 1 to 2 |
| Coloured side | Inside of the bend between Foot and Upright | 2 choices |
Some ranges depend on the other sizes and on the metal you choose.